When you call about a heating or cooling problem, the first thing you get is a straight answer about what the system is probably doing and what a visit would involve. That call is answered by someone who knows the trade, can scope the job on the phone, and will give you a price before anything is scheduled. Whether the issue is a furnace that will not light, an AC that is running but not cooling, or a heat pump that has stopped switching modes, we work through what is happening before we quote anything.
We handle the full range of residential and commercial HVAC work in Timberwood Park and the surrounding Bexar County area. Repairs, replacements, seasonal maintenance, ductwork, thermostats, indoor air quality, and emergency no-heat and no-cool calls: all of it is on the table.
Call (830) 632-8965 to get started.
Some properties in Timberwood Park are built in ways that make conventional ducted systems difficult or impractical. A room addition that was framed without duct runs, a converted garage, a detached structure, or a space that was always conditioned separately from the main system: these are the situations where a ductless mini-split does what a central system cannot.
A mini-split handles both heating and cooling from a single outdoor unit paired with one or more indoor air handlers mounted on the wall or ceiling. There are no ducts to run, no existing ductwork to tie into, and no need to tear into walls to extend the supply side of a system that was never designed to reach that space. Each indoor unit conditions its own zone independently, which means a room that has always been too hot in summer or too cold in winter can be brought under control without affecting the rest of the house.
For properties where different areas of the building have genuinely different comfort needs, a multi-zone mini-split setup allows each space to be controlled on its own schedule and temperature. A home office that runs all day while the rest of the house sits empty, or a second floor that traps heat while the ground floor stays comfortable, are both good candidates. The installation involves placing the outdoor unit, running refrigerant line sets to each indoor head, and commissioning the controls. Airflow balanced rather than left to chance means the system is set up for the actual load in each zone, not just plugged in at nominal capacity.
Mini-splits that are already installed need the same diagnostic attention as any other system. A unit that is not cooling, not heating, or throwing a fault code gets checked the same way: refrigerant charge, coil condition, blower performance, and the control signal between the indoor and outdoor units. The age of the system changes the answer, and that gets said.
Getting somebody to the property quickly matters more when the system is completely down than when a tune-up is overdue. We take emergency calls every day from 6:00 AM to 9:30 PM, including weekends, for no-heat and no-cool situations that cannot wait. When you call, we go through what is happening, scope the likely cause, and confirm the price before the visit is booked. We do not quote arrival windows, but emergency work is treated as a priority.
For properties where somebody has to stay home, or a tenant needs to be worked around, the scheduling conversation happens on the call. Rental properties and occupied commercial spaces have different constraints than an empty house, and we account for that when setting up the visit. The technician who comes out works to the scope confirmed on the phone.
The call moves faster when you know a few things before you pick up the phone. You do not need to have the answers, but having them saves time.
We will ask about the age of the equipment and the layout of the space if it is relevant to the scope. For a replacement quote, the square footage and the number of zones matter. For a repair call, the symptom and the system behavior are usually enough to scope the visit on the phone.
HVAC pricing depends on what the job actually involves, and that is not always clear until the technician has looked at the system. A refrigerant leak diagnosis, a blower motor replacement, and a full system replacement are different scopes with different costs. The price is confirmed before the visit is scheduled, and the scope is confirmed on the call.
What moves a quote up or down is usually one of three things. The first is what the fault turns out to be. A capacitor reading low is a different repair from a failing compressor, even if the symptom on the surface looks similar. The second is what has to be reached to do the work. Equipment in a difficult location, ductwork that runs through an attic, or an air handler installed in a tight space all affect how long the job takes. The third is whether a repair makes sense at all. If the system is old enough and the repair is significant enough, replacement is often the more honest answer, and we say so.
No pressure and no gimmicks, just straight HVAC answers. What the work involves is covered on the page that lists our HVAC services.
Call (830) 632-8965 and the price is set before anything is scheduled.
Leaking ducts are one of the more common causes of rooms that never quite reach the set temperature, even when the system itself is working. When conditioned air is escaping into an attic or a wall cavity before it reaches the supply register, the room at the end of the run gets whatever is left. Duct sealing closes those leaks and restores the pressure balance across the system. It also reduces the load on the air handler, which has been working harder than it should to compensate.
A furnace that will not light, blows cold air, or shuts off before the house reaches temperature is one of the more urgent calls we take in the region. The diagnostic starts with what the system is doing: whether it is cycling on and off without completing a heating cycle, whether the blower is running without heat, or whether the unit is not responding at all. Ignition faults, pressure switch issues, and limit switch trips are common causes, and each one points to a different repair.
A thermostat that is reading incorrectly or not communicating properly with the system can cause the same symptoms as a mechanical fault. When a thermostat upgrade is the right answer, installation involves confirming compatibility with the existing equipment, wiring the new control, and testing the system through both heating and cooling modes. Smart controls that allow scheduling and remote access are a straightforward upgrade for most systems.
For a property that does not have central cooling, or where the existing system is being replaced entirely, installation involves load calculation, equipment selection sized for the space, refrigerant line runs, and connection to the air handler. Evaporator coil placement and airflow through the supply side are part of the installation, not an afterthought.
When registers that used to push good airflow are barely moving air, the cause is usually a blower issue, a clogged filter or evaporator coil, or a duct problem between the air handler and the register. Air handler and blower service covers the motor, the wheel, and the housing. Evaporator coil cleaning restores heat transfer and airflow when buildup has restricted the coil surface. Both are worth checking before any refrigerant or compressor diagnosis is done, because restricted airflow mimics refrigerant problems closely.
A system that turns on, runs briefly, and shuts off before completing a cycle is working harder than it should and conditioning less than it needs to. Short cycling can point to an oversized system, a refrigerant issue, a dirty coil, or a fault in the control circuit. It is also hard on compressor life, so it is worth diagnosing before it becomes a more expensive problem.
We cover Timberwood Park and the surrounding communities in Bexar County, including Bulverde, Hollywood Park, Hill Country Village, Shavano Park, and Fair Oaks Ranch. If your property is in this part of the county and you are not sure whether it falls within the service area, the call will confirm it quickly.
Residential properties, rentals, and commercial buildings are all covered. The scope and the price are confirmed before the visit is scheduled, and we are available every day from 6:00 AM to 9:30 PM.
That depends on the filter type, the size of the home, whether pets are present, and how much the system runs. As a general guide, a standard one-inch filter in a home that runs the system regularly should be checked monthly and replaced when it is visibly loaded. Thicker media filters last longer. The technician can give a more specific recommendation based on the equipment during a maintenance visit.
Yes. After an installation, the system is started and run through both operating modes to confirm it is performing correctly before the visit ends. That includes checking refrigerant pressures, airflow, thermostat response, and that the system reaches operating temperature or cooling capacity before anyone leaves.
Homes in this part of Bexar County tend to run their cooling systems hard through long, humid summers, which puts real hours on compressors, coils, and blower motors over time. Duct issues in attic spaces are also common, since heat in an unconditioned attic degrades duct seals faster than in a conditioned space. The call covers what the system is doing, and we scope the likely cause before the visit is booked.
It is always reasonable to get a second opinion on a significant expenditure like a full system replacement. What matters is that any quote you compare covers the same scope: matched equipment, proper load calculation, and what installation includes. A lower number that skips any of those steps is not a comparable quote.
Yes. We take calls from property owners, landlords, and commercial building managers across Timberwood Park and the surrounding Bexar County communities. The process is the same as a residential call: scope the job on the phone, confirm the price, and schedule the visit. For occupied rentals or businesses that need to stay open during the work, we account for that when setting up the appointment.
Call (830) 632-8965 and tell us what the system is doing.
We will ask a few questions about the equipment and the property, scope the job on the phone, and give you a price before anything is scheduled. That is how every job starts, whether it is a repair, a replacement, or a system that has stopped working entirely.
Call (830) 632-8965 to reach New Braunfels HVAC Company and get a straight answer about what comes next.
HVAC service nearby: Bulverde, Fair Oaks Ranch, Scenic Oaks, Garden Ridge. See our complete coverage area.
From a quick AC repair to a full system replacement, we handle the heating and cooling work that keeps Timberwood Park homes and commercial buildings running through long Texas summers and the cold fronts that follow. The services below cover the full range of what we do, along with what each visit includes, who it fits best, and a practical note on timing or value. Call us with any questions and we will walk through the options before anything is scheduled.
| HVAC Service | What It Covers | When You Need It | What to Keep in Mind |
|---|---|---|---|
| Whole-Home Dehumidification & Humidity Control | Dehumidifier sizing and selectionAir handler integrationHumidity target settingSystem test across the full home | Bexar County homes where indoor air feels heavy or musty even when the AC is running | High indoor humidity in this region can persist through spring and fall even when temperatures are manageable. A whole-home unit operates independently of the cooling cycle and holds humidity to a set target. |
| Full System Installation & ReplacementMost Popular | Load calculation and proper sizingMatched condenser, air handler, and coilRefrigerant line and electrical connectionsSystem testing and airflow verification | Homeowners whose system is aging, requiring repeated repairs, or no longer keeping up with the cooling load | Replacing components from the same equipment generation keeps efficiency ratings accurate and avoids compatibility problems that come from mixing old and new hardware. |
| Emergency HVAC Service | No-heat and no-cool responseSystem-down diagnosisRepair or temporary stabilizationPrice confirmed before the visit | Any situation where the home is not cooling in July or the heat is out on a cold night and it cannot wait for a routine appointment | We take emergency calls every day from 6:00 AM to 9:30 PM. Having the make and model of the equipment ready speeds up the phone diagnosis before the visit is scheduled. |
Call us at (830) 632-8965 and we will go through the details, confirm the price, and get the right service scheduled for your home or building.
(830) 632-8965