Replacing a part is the easy half of any HVAC call. The useful half is understanding why the part failed, because a compressor that burned out for lack of refrigerant will burn out again if the leak is not found first, and a blower motor that seized because of restricted airflow will take the next one with it too. That is where the diagnostic matters, and it is where the call begins before anything is scheduled or quoted.
We handle heating and cooling for homes, rental properties, and small commercial buildings across Dripping Springs and the surrounding area.
Whether the system has stopped altogether or is just behaving differently than it used to, call (830) 632-8965 and describe what the property is doing. That is enough to start.
A town this size runs a mix of housing that reflects how the area has grown: established homes with original equipment that has never been replaced, newer builds where the system is still under its first decade of use, and additions or detached structures that the original ductwork never properly reached. Each one comes with its own set of common problems.
A sound that was not there last week is the system pointing at something. Grinding from the air handler usually means a blower motor bearing is going. A rattling at the condenser can be debris, but it can also be a failing compressor making its first warning. Squealing from the indoor unit often traces to a belt or a motor. The diagnostic starts with what the sound is and when it appears, because those two things narrow the cause before the technician opens anything.
When the air inside a home feels stale, dusty, or heavier than it should, the HVAC system is involved whether or not the cooling is working correctly. A whole-home air filtration system integrates with the existing air handler and filters the air that moves through it rather than treating one room at a time. Humidity is part of this too. In a climate where summer humidity stays elevated, a whole-home dehumidifier handles moisture independently of the cooling cycle, which means the AC can run at the cycle length that suits temperature control without leaving the air damp.
A rooftop unit that is running but not conditioning the air efficiently is a common call from small commercial properties. Coil fouling, refrigerant loss, and economizer problems all reduce output without stopping the unit entirely, which means the problem often goes unnoticed until the utility bill climbs or a space becomes uncomfortable. Repair and replacement of rooftop units is part of what we do, and the diagnostic process is the same as it is for residential equipment: find the cause before quoting the fix.
A tune-up is not a box to check. It is a full inspection of refrigerant charge, blower performance, evaporator coil condition, capacitor readings, and airflow through the system. A capacitor that is reading low, a filter that has been in place too long, or a coil that has accumulated a season's worth of buildup: these are the things a maintenance visit finds before they become a breakdown call in the middle of July. For older equipment especially, a tune-up also gives a clear picture of where the system stands and what it is likely to need.
HVAC pricing moves with the job, and the job is not fully known until the system is looked at. What changes a quote is what the fault turns out to be, what has to be reached to fix it, and whether a repair makes more sense than a replacement given the age and condition of the equipment. The age of the system changes the answer, and that gets said.
What the call covers is the scope of the job, what the visit includes, and the rate before anything is put on the schedule. You get the price on the phone before a technician is dispatched. If the diagnostic turns up something beyond what was discussed, that gets explained before any additional work is done. Nothing moves forward without your agreement.
A repair call, a seasonal tune-up, and a full system replacement are different scopes with different pricing. Describing what the system is doing is enough to start the conversation. See our HVAC services page for how the work is handled.
Call (830) 632-8965 for a quote.
No pressure and no gimmicks, just straight HVAC answers, and that starts the moment you call. When a property has no heating or no cooling at all, the call is prioritized. We take emergency no-heat and no-cool calls every day from 6:00 AM to 9:30 PM, and short-notice work is something we handle regularly.
For tenants or businesses that have to stay open, the visit is scoped to work around the space as much as the job allows. The technician who comes out knows what the call involves before arriving, because the diagnostic conversation happens on the phone first. That means less time spent working out what to look at and more time spent on the actual repair.
We do not quote arrival windows, but the process from call to scheduled visit is straightforward. Describe what the property is doing, confirm the price, and the visit is arranged.
A system that was installed for a home as it was built may not be right for the home as it stands today. An addition that was put on without revisiting the load calculation, a converted garage, a sealed attic that changed the thermal envelope: any of these can mean the existing equipment is working harder than it should or failing to condition parts of the property at all.
When a full system replacement comes up, the sizing conversation matters as much as the equipment selection. A unit that is too large short-cycles, which means it runs in short bursts that do not remove humidity and wear the compressor faster. A unit that is too small runs continuously and still cannot hold the set temperature on a hot day. The replacement is sized for the actual load in the space, not simply matched to the nominal tonnage of the old unit.
This part of Texas sits in a climate where winters are variable but rarely severe, which makes heat pumps a strong fit for many properties. A heat pump handles both cooling and heating from a single outdoor unit, running efficiently through the mild heating season without the fuel cost of a furnace. For properties replacing aging equipment, a heat pump replacement is often the more efficient answer. For properties that already have a heat pump showing signs of wear, repair is always evaluated first before replacement is discussed.
Mini-split and ductless systems solve a specific problem: conditioning a space that has no duct connection and where running new ductwork is not practical or cost-effective. In Dripping Springs, that comes up in detached structures, converted garages, room additions, and older homes where the original duct layout left certain areas consistently uncomfortable.
A ductless system has an outdoor unit and one or more indoor air handlers mounted in the space being conditioned. Each indoor unit handles its own zone independently, which means a detached office can be cooled without affecting the main house system, and a room addition can be brought into the comfort range without modifying the existing ductwork. Installation involves selecting the right capacity for the space, placing the indoor unit for even airflow, and running refrigerant line sets through the wall. The thermostat and control setup is part of the installation.
We serve Dripping Springs and the communities around it in Hays County, including Driftwood, Belterra, Bear Creek, Bee Cave, and Woodcreek. Calls from across this area are handled the same way: scope the job on the phone, confirm the price, then schedule the visit.
If your address is near Dripping Springs and you are not sure whether it falls within the service area, the call will confirm it. We are available every day from 6:00 AM to 9:30 PM.
Call us and let us know the access window. We are available every day from 6:00 AM to 9:30 PM, which gives some flexibility around standard working hours. The exact scheduling is worked out on the call based on what is available.
Yes, we handle heating and cooling for small commercial buildings including rooftop unit repair and replacement, zone control, and thermostat and smart-control installation for multi-space layouts. The process is the same as for residential work: the job is scoped on the phone, the price is confirmed before the visit is scheduled, and the diagnostic is explained before any repair is quoted. We cover Dripping Springs and the surrounding Hays County area including Bee Cave, Belterra, and Driftwood.
That depends on what is wrong with it. Some faults are worth repairing even on older equipment if the rest of the system is sound and the repair cost is reasonable relative to the replacement cost. We go through that honestly during the visit rather than defaulting to replacement, and the decision is yours to make with the full picture in front of you.
Additions and detached structures are among the most common sources of uneven comfort calls. The original duct system was sized for the home as it was built, and an addition often gets inadequate airflow or none at all. A ductless mini-split is frequently the right answer for a detached structure, while an addition connected to the main system may need duct work extended or the system resized to handle the additional load. The call is where we work through which situation applies.
Describing what the property is doing is enough.
If the system is making a sound it did not make before, if certain rooms will not hold temperature, if the unit is running but the air is not right, call (830) 632-8965 and walk through it.
The rate is confirmed before anything is scheduled, and nothing moves forward until you know what you are agreeing to.
Call New Braunfels HVAC Company at (830) 632-8965 and we will take it from there.
Heating and cooling work in the surrounding towns: Wimberley, Buda, Kyle. Everywhere else we go is in our complete coverage area.
From a quick AC repair to a full system replacement, we handle the heating and cooling work that keeps Dripping Springs homes and commercial buildings running through long Texas summers and the cold fronts that follow. The services below cover the full range of what we do, along with what each visit includes, who it fits best, and a practical note on timing or value. Call us with any questions and we will walk through the options before anything is scheduled.
| HVAC Service | What It Covers | When You Need It | What to Keep in Mind |
|---|---|---|---|
| Full System Installation & ReplacementMost Popular | Load calculation and proper sizingMatched condenser, air handler, and coilRefrigerant line and electrical connectionsSystem testing and airflow verification | Homeowners whose system is aging, requiring repeated repairs, or no longer keeping up with the cooling load | Replacing components from the same equipment generation keeps efficiency ratings accurate and avoids compatibility problems that come from mixing old and new hardware. |
| Ductwork Repair & Sealing | Static pressure and airflow testingDuct leak identificationSealing and connection repairRegister and grille assessment | Homes with uneven temperatures, high energy bills, or rooms that never reach the set temperature | Duct leaks in attic spaces are common in older Hays County housing stock. Conditioned air lost to an unconditioned attic adds directly to cooling costs through the summer. |
| Emergency HVAC Service | No-heat and no-cool responseSystem-down diagnosisRepair or temporary stabilizationPrice confirmed before the visit | Any situation where the home is not cooling in July or the heat is out on a cold night and it cannot wait for a routine appointment | We take emergency calls every day from 6:00 AM to 9:30 PM. Having the make and model of the equipment ready speeds up the phone diagnosis before the visit is scheduled. |
Call us at (830) 632-8965 and we will go through the details, confirm the price, and get the right service scheduled for your home or building.
(830) 632-8965